Page 1 of 1
Train Routing Through Major Junctions
Posted: Mon Dec 26, 2016 9:03 pm
by David
Please leave the following signals on red unless there is a train going though the territory. This is in effort to keep train going to their proper destinations.
- Eastbound Main 1 and Main 2 CP Lynnwood
- Westbound Main 1, Main 2, Main 3 CP East Barstow
- Westbound Valley Junction
- Eastbound CP Hutt
- BNSF Jct at Mojave All Tracks
- Kern Junction All Tracks
- Mojave Sub Between Cable and BNSF Junction
We ask that if you do route a train though these location please do not fleet the signal, set it to the yellow (Non-Fleeted) Mode.
Re: Train Routing Through Major Junctions
Posted: Mon Dec 26, 2016 9:38 pm
by TheVARailFan
Westbound Valley Jct would make a little more sense.
Re: Train Routing Through Major Junctions
Posted: Tue Dec 27, 2016 1:02 am
by David
Yes it would, I also added Eastbound CP Hutt
Re: Train Routing Through Major Junctions
Posted: Sun Jun 16, 2019 9:20 am
by infernal
Logged in, Signals fleeted at West Daggett and Lenwood, this is the result.
Two BNSF trains supposed to go to BAR, UP off at Daggett.
Would post on FB but dont like the idea its an open group and all my friends can see when I post, then start asking me questions about train sim
Re: Train Routing Through Major Junctions
Posted: Wed Sep 18, 2019 10:15 pm
by gnukix
I keep seeing signals through Barstow in fleet. One train for sure went out at Seligman today that should have been into Barstow yard, and based on what was travelling yesterday /last night and what was in the yard this morning probably four or so others were fleet signaled right out Seligman.
I clobber them to red and leave them that way when I log off.