Run 8 Version 2 Update 4 & Selkirk/Mohawk Update

[David]

Run 8 has released Update #4 for V2 Today. Below are a list of changes

• Adjusted the threshold PSI/Second reduction-rate necessary to trigger the Emergency-Application Valve; this solves a minor issue reported about inconsistent emergency-application dump behaviour. (Since the customer who reported this is from Australia, I've added the extraneous “u” to the word “behaviour” in his honor)
• Corrected a crash-condition null reference that sometimes occurred during uncoupling
• Fixed two code mistakes with NORAC signals regarding non-dwarf MediumClear and LimitedClear aspects (for the Selkirk and Mohawk routes)
• Fixed a code mistake regarding the rear trucks of the SD40 Tunnel Motors
• Fixed another possible cause of the random loss of Simulation Settings when the program exits
• Fixed issue with humped-cars slamming too hard into bowl-tracks that are close
  to full

An update was also released for the Selkirk/Mohawk Region which addresses track, signal, and scenery issues.
You can find both updates on the Run 8 Studios Website.

[fastflame]

I downloaded the #4 update. I have backed up ALL files in the Run8 directory. After I run the update, what specific files need to be recopied back to the active run8 folder(s)? I am anxious to install the new LA route, but I assume I need the #4 update loaded first. Any advise.

[David]

Just the industry config in the V2Routes/Regions/SouthernCA folder